Open Transport PPP Setup
This page will give you the essentials in settings up PPP/TCP/IP for the mac using
OT/PPP. At this point you should have a valid username and password.
Configuration
-
From the Control Panels run PPP
-
Select Registered User
-
In Name: field enter your user name.
-
In Password: field enter your password.
NOTE: Your password is case sensative. For example 'MYPWORD' is not 'mypword'.
-
In Number: field enter the nearest local POP (Point-Of-Presence) number.
NOTE: Refer to our Points Of Presence (POPs)
page to find a local POP.
![](/images/support/macintosh/macos_otppp1.gif)
-
Select File/Configurations
-
Select either default or one you created.
-
Click Make Active
![](/images/support/macintosh/macos_otppp2.gif)
-
Click done
-
Select Edit/User Mode
-
Select Basic
![](/images/support/macintosh/macos_otppp3.gif)
-
Click OK
-
Select PPP/TCP/IP
-
Set Connect via: to PPP
-
Set Configure: to Using PPP Server
-
Erase everything in Name server addr:
Enter: 206.40.47.2 hit the return key
Enter: 206.40.47.3
-
Erase everything in Search domains:
Enter: accesscom.com
![](/images/support/macintosh/macos_otppp4.gif)
-
Close the TCP/IP window and Save changes.
-
Select PPP/Modem
-
Verify the Connect via: field corresponds to your modem.
-
Enusre your modem is selected.
-
Set Sound: to On
-
Set Dialing: to Tone
-
Uncheck Ignore dial tone
![](/images/support/macintosh/macos_otppp5.gif)
-
Close the Modem window
Usage
-
From the Control Panels run PPP
-
Click Connect
That's it!